How to solve these problems about understanding the anime measuring instrument?

How to solve these problems about understanding the anime measuring instrument? To master its precise measurement methods, it is essential to promptly resolve any problems encountered during its use. Below are several methods for troubleshooting problems.

Anime measuring instrument

1. Z-axis cannot be focused

It may be that the fixing screws are locked, just loosen the fixing screws on the pillar. Or if the motor driver is damaged, you need to contact the supplier for repair.

2. Accuracy failure.

This includes inaccurate accuracy of the a.x.y-axis, poor accuracy of two coordinate measurements, large angle indication errors, and large measurement errors in different planes. To deal with such faults, attention should be paid to correction and adjustment.

3. Cleaning and maintenance

If you want to reduce the number of failures of the anime imager, you should pay attention to the maintenance of the instrument at ordinary times. The storage environment of the instrument is quite important and should be placed in a clean and dry room to avoid mold on the surface of optical parts, rust on metal parts, and peeling of dust and debris. The surface of the component should be kept clean and should not be touched by hand. It should be cleaned regularly.

4. There is no image in the image area and it appears gray

It is possible that the video capture card is not properly plugged in. Turn off the computer and instrument normally, unplug the power plug, then open the host box, remove the video capture card, and reinsert it again. After confirming that it is plugged in properly, restart the computer. If the slot is changed, the driver needs to be reinstalled.

Alternatively, if the video capture card driver is not installed properly, reinstall the video capture card driver according to the instructions in the manual, or if the video capture card parameters are not set correctly, click on the menu Image ->Image Video Settings... or right-click in the image display area and select Image Video Settings... from the pop-up menu to open the Image Settings dialog box. Set the correct brightness, contrast, and other parameters.

5. Projection screen malfunction.

When there is a sound during rotation, impurities (such as rust stains) on the end face can be cleaned, and positioning bearings can be replaced. When rotating, the friction is strong, and the locking screw can be loosened or the friction can be changed. When the rotation is uneven, the dial seat, friction wheel, friction wheel shaft, etc. can be replaced. When the projection screen rotates without counting, the angle friction mechanism can be tightened, the signal line can be welded, and the connection and insertion can be done properly.

6. Projection imaging malfunction.

Blurred imaging, dark areas in imaging, black spots in imaging, and low contrast light in imaging can be used to clean the objective lens, projection screen, workbench glass, spotlight, reflector, etc. Adjust or replace the filament. If the power supply voltage of the bulb is too low, install a main power regulator.